Beogram 4004: Replacement of Convertible DIN 7 Plug with a Female Socket and Adapter Cables

While enjoying the Beogram 4004 that I recently restored I was looking for an adequate modern replacement for its convertible DIN 7 plug. This plug is a special design that does not seem to be made anymore. Here is a picture of its business end:

The picture shows the plug in its DIN5 configuration, i.e. it can now connect with any standard DIN5 amplifier input. The two (threaded) orifices above the pins can hold two more pins, which can be bolted in if the Beogram is to be connected to a Beomaster 2400 to take advantage of its remote control, which can be used to start/stop the Beogram. In essence these two additional pins carry the remote control signals for the Beogram. But, of course, since this is a male plug, the pins have to be removable if the Beogram is to be used in a standard DIN 5 setting.

Sadly, these plugs are nowhere to be found these days, and so, if a new plug is desired, another approach needs to be found to preserve the above 'convertibility'. My solution was to replace the plug with a female DIN 7 socket. That way DIN5 (or DIN5-to-RCA) jumper cables can be used for non-B&O set-ups and DIN7 jumpers can be used to connect to B&O setups. In essence, this modification gives the Beogram 4004 the same connectivity design like the later Beogram 800x, which have a panel mount DIN7 socket in their back panel to receive a suitable jumper cable.

It was pretty difficult to find a decent female cable mount DIN7 socket, but finally Steve at soundsheavenly.com saved the day by providing me with a few DIN7 Deltron sockets for cable mounting.

Here are a few impressions: This shows the socket installed. The red and white leads are the signals and the yellow and blue leads carry the remote control.

It is important to note that the signal leads on a female sockets need to be soldered to the other side of the connectors since male and female plugs have mirrored pin assignments to properly maintain the signal chain through the connections. This shows the fully assembled socket:

This is how it looks with a DIN5 jumper cable (also provided by Steve) plugged in:

This Beogram 4004 is finally ready to be shipped back to its owner!