Canada Beomaster 8000: FM and FM Interface Boards

The Beomaster 8000 FM section is on two boards, the FM board and FM Interface board. The restoration task on these two boards is primarily cleaning, replacing capacitors and reflowing solder joints on the board connectors.

Here are the two boards as they were received.

I removed the components that are being replaced then cleaned the boards.

I didn't run into anything dramatic on these two boards which is how I like it. Several of the removed capacitors were out of tolerance.

I replaced the capacitors 2.2uF and under with WIMA MKS capacitors. For values higher I replaced using 105°C rated electrolytic capacitors.

Here are the completed boards ready to be reinstalled in the Beomaster.

Beomaster 8000: Finishing up the capacitor replacement

This Beomaster is getting closer to a test run. I completed the capacitor replacement on all of the boards now. There were no real surprises there. I did find a higher than normal number of capacitors that were out of tolerance and quite a few on the border of being out of tolerance. In addition to the capacitor replacement I also replaced some opamp devices and I reflowed the solder joints on all of the board connectors.

Here are the FM and FM Interface boards.

Next, the preamplifier board.

I had seen quite a bit of dirt, grime and rust on this Beomaster in the previous blog posts so I was wary of possible corrosion on the circuit boards. You can see that the six input level trimmers have some sort of grime on the plastic housing.

Sure enough, several of these trimmer knobs would barely turn. I used two types of Deoxit spray on the trimmers. Each trimmer has three slots that expose the inner workings and I was able to flush the grime and get them working smoothly again.

Along with the capacitor replacement there are seven audio opamp devices that get replaced. Beolover just posted a nice description of why we replace these particular opamps. Here is the preamplifier board with the capacitors removed and new eight pin sockets ready for new LF353N opamps.

...and here is the completed preamplifier board.

The Filter & Tone Controls board also has some audio opamps in the signal path that get replaced. There are also a few capacitors to replace. The tone control sliders and switches also received Deoxit treatment so they operate smoothly and have clean contacts.

As I did on the preamplifier board I added sockets for the new opamps. The sockets are nice because it makes it safer to install the new opamps (no solder heat gets applied to the actual device). Having the socket also makes it easy to switch out a different opamp in the future should that become necessary.

The display and microcomputer boards have only two capacitors each (that get replaced). The display board will be revisited later to change out the display segment LEDs and to replace the four indicator lamps.

Here are the two replacement capacitors on the display board.

This is also just a first visit to the microcomputer board. I will come back to it and replace the two oscillators later.

The 22uF (9C85) capacitor on the left has been replaced before. The original capacitor leads were cut and the replacement capacitor soldered to the remaining leads (still soldered to the board). That isn't necessarily bad but I prefer removing the capacitor and properly soldering in a new one. 

An important thing on this microcomputer board is that some of the component leads must be soldered to both sides of the board. The negative lead of 9C85 is one of those type of components.

The capacitor replacements on this Beomaster 8000 are now all done. I can reinstall the preamplifier, FM, FM Interface, Filter & Tone Controls boards in the Beomaster chassis now and start connecting their cables.