Beocord 9000: Restoration of the Peak Program Meter with SMD LEDs (III)

This is the third installment of my report on how to rebuild the peak program meters (PPM) of a Beocord 9000. The first two posts report on the installation of SMD LEDs to replace the original faulty LEDs on the PPM PCB, and the re-attachment of the plastic covers. This post demonstrates the installation and brightness adjustment of the rebuilt PPM.

The first step was to replace the original current limiting resistors with the correct values for the modern SMD LEDs. Modern LEDs typically need much less current and achieve higher brightness than the original LEDs. This is reflected in the much larger resistor values that my initial experiments yielded to achieve similar or slightly increased brightness with the new LEDs. The original values were 180 Ohm for the red and 120 Ohm for the green ones. The SMD types required 470 Ohm for red and 330 Ohm for green for slightly enhanced output (see first post). The resultant currents were in the 10 mA range, while the original LEDs easily draw 40 mA, while having a lower intensity.

Here is a picture of the original resistor bank (the 8 leftmost resistors)

This shows the new resistors installed. Despite the PPM having 16 LEDs there are only 8 resistors. This is due to the fact that the two left and right PPMs are multiplexed at 60 Hz, i.e. only 8 are on at a time. This is seen in the signals of the two common anodes (pin 1 and 2 on the display board) which each drive one of the PPMs:

This shows the new resistors installed:

And here after installation of the rebuilt PPM:

And in action:

It turned out to be a good idea to fix the two display boards in sequence, i.e. leave one in while taking out the other. this allows to realign the one that was out with the one that is still in when putting it back. That way it is easy to get it back into the right position that it fits perfectly into the plastic bezel. Another helpful thing to do is to mark on the headers of the displays how far they were inserted into the PCB. This is important to get the right slant of the displays that matches the cover.

On to replacing the scale illumination bulb with a red/green SMD LED.