Featured Post

Beolover SyncDrive: DC Platter Motor Replacement for Beogram 4002 and 4004 (Type 551x and 552x)

Late Beogram 4002 and the 4004 (Types 551x and 552x), which have DC platter motors instead of the earlier synchronous AC motors usually suff...

Tuesday, October 27, 2026

Beogram 4002 (5513): A New Arrival from California - First Impressions

Today I started working on a Beogram 4002 (Type 5513) that was sent to me a while ago by a customer in California. It arrived safely packaged in a Beolover shipping container, and no shipping damage occurred. This shows the unit on my bench:

Like so many, it has a fairly scratched dust cover:

I removed the hood:

The aluminum surfaces are still pretty decent. The platter has a bit of scratching in the center:


I guess someone tried to install it upside down and missed the center pin. There are some other minor marks on it:


The keypad has the usual smudges in the coating from using it:

Luckily, these damaged 4002/4004 keypads can now be restored to a like-new appearance with a new keypad plate. See here for options if you are interested in getting your keypad fixed.

The wood plinth is toast. It has significant damage on the right front corner:

I removed the aluminum plates and platter and had a look below deck:

It looks fairly 'original', but there was some previous human interaction, as is evident from the liberally spread black paint near the tracking sensor


and the platter bearing:
We will see soon how much of this mess I can remove.
The transport lock bushings are also gone. The locks are completely 'naked' around the orifices where the lock bolt goes through:

After this visual inspection, I plugged the unit in and pressed START. The carriage started moving, found the LP setdown point, and the solenoid engaged. The platter motor was also running.

All good signs for a restoration. I am confident this unit can be returned to like-new condition and performance. Stay tuned for my restoration report for this Beogram! 









No comments:

Post a Comment

Comments and suggestions are welcome!