Beogram 4002 (5513): Another Beogram From Houston - Mechanical Work

The restoration work on this Beogram 4002 (Type 5513) begins with the various mechanical restoration tasks.

Those include cleaning out the debris from the cabinet base and some disassembly of the floating chassis components for cleaning and lubricating.

The arm lowering & raising lever is attached to the fixed arm.  The pivot for that lever can occasionally get gunked up so we typically remove it for a clean and lubrication.

The arm lowering damper is also cleaned.  The rubber washer on the end of the plunger gets replaced with a new washer and the metal part of the plunger is lightly lubricated with a silicone lubricant.

The tangential arm spindle parts are removed for cleaning and lubrication.
I don't immediately re-install the spindle however as I find it easier to make a few Service Manual mechanical adjustments with the tangential arm assembly free to slide back and forth.

Before making any Service Manual mechanical adjustments I like to move the four set screws that sit underneath the two metal rails the tangential arm assembly rides on.

These set screws are for adjusting the height of the rails but the slotted end to make the adjustment with sits underneath the floating chassis.  I remove them and re-insert them from the top.  This allows any change in their height to be made from the top side of the floating chassis without having to remove the floating chassis from the cabinet.

Here is a photo of one of the re-inserted set screws.

That gives a little peace of mind in case some change in the tangential arm assembly height is necessary.  Normally it shouldn't be but the set screws allow about 3 mm of height adjustment.

Next I reassembly the tangential arm assembly and go through the adjustments to make sure the arms are perpendicular to the back rail, parallel to each other and have the proper distance to the platter.

The Service Manual says the distance between the Fixed arm and Tonearm is 7.7 mm.

The top of the Fixed arm to the top of the platter (metal) surface has to be 23 mm.

After that is set the tops of the two arms (Fixed and Tonearm) should be even.  If they are not, the Tonearm height can be adjusted. 

With a phono cartridge mounted I check that the Tonearm and cartridge vertical alignment (azimuth) is good.

I set the Tonearm lowering limit so the stylus of the cartridge is about 0.5 mm above the lower platter rib.

I calibrated the tracking force of the Tonearm/Cartridge so that it measures 1.0 gram with the tracking force knob set at 1 gram. 

After that calibration I set the tracking force knob to 1.2 grams.

Before installing the Beolover Tracking Sensor Lamp component to the Beogram 4002 Tracking Sensor Assembly, I checked and adjusted the metal aperture so it is 1 mm above the Tracking Sensor.

The Beolover Tracking Sensor Lamp was then installed followed by the Tangential Arm Assembly spindle parts.  The plastic pulley on the spindle was replaced with an aluminum pulley.

When the spindle was installed I lubricated it with a mixture of grease and oil.  Not too thick and not too thin.

The floating chassis components can now be re-installed in the Beogram 4002 cabinet base where the suspension will be adjusted so the top of the platter is even with the cabinet aluminum deck.

Along with that, the platter motor and reservoir capacitor assemblies will be installed.

I'm pleased with the mechanical adjustments so far.  The re-installed floating chassis aligns good with the aluminum deck plate so it is on to the rest of the electronic restoration tasks.

Those include the restoration work on the main PCB, the output (audio muting) PCB, the LED lamps for the speed indicators, the arm detector lamp (in the Fixed arm) and the contact cleaning on the Beogram control panel buttons...Plus all of the related adjustments.