After installing my new BeoloverRIAA pre-amplifier design in the Beogram 4002 that I just finished up, I set out to put the enclosure back together and bolt on the hood when I realized that I had completely forgotten about the bent and damaged system ground terminal in the back:
It turned out that I needed to cut the bold off with a saw since the threads were too damaged to get the rusty nut off that was installed. After getting the bolt out I installed a new 3 mm bolt with the appropriate insulating shoulder washers:
O.k...it seems I am done now! Beolove is in details! Time to ship this 4002 back to its owner!
No comments:
Post a Comment
Comments and suggestions are welcome!