Featured Post

Beogram 4002: Restoration of DC Motor Video Published - Check It Out!

By popular request (really, I got quite a few emails about this!...;-), I finally completed my Beogram DC motor restoration video! It demon...

Sunday, June 4, 2017

Beogram 4000: Replacing the Reservoir and Motor Electrolytic Capacitors

After gold plating all of the switch terminals in the Beogram 4000 that I am restoring right now, it was time to rebuild the electronics. I usually start out by replacing the old reservoir and motor capacitors that are often out of spec and on the brink of failure. This shows the original units:

A while back I developed a 3D printed capacitor fixture that holds the (smaller) modern replacements neatly in place:
This assembly is a drop in replacement for the original capacitors since it uses the same retaining strip:
On to the circuit boards.



No comments:

Post a Comment

Comments and suggestions are welcome!