Beogram 4002 (5513): Replacing the Electrolytic Capacitors

Today was recap day for the Beogram 4002 (5513) that I am currently restoring. I used my recently developed 3D adapter to replace the combined 4700/1000uF capacitor with modern, smaller 105C grade cans. Here are a few impressions.This is the original setup:

This is the 3D printed adapter with the new capacitors:

And a detail picture of the connections during the installation process:

And mounted in place. The 3D printed adapter fits into the original capacitor mounting clamp:

After the reservoir caps I also recapped the main board. This shows the original condition:

And after replacing all the Ta and Al electrolytic capacitors:

The sole capacitor on the output relay board will be exchanged once I take the keypad out to install a rebuilt replacement supplied by an expert beofriend in Denmark.